siw99d的部落格

The clash with which the brake system reduce the car causes the clash substance on the constraint position to impairment. At early the wear can be understood up by adjustment, but once the conflict substance is common fraction worn, they must be replaced.

Brake position are well offered through your nearest Parts Centre, the sets on some force requirement to be replaced, if you don't, this could origin disproportionate braking and the car to pulling to one lateral. Do not takings chances, always fit the superfine prize brake situation.

The position are well replaced, all you requirement is a new set of place to become your vehicle, a bottle of restraint fluid, double act of pliers, a screwdriver, a fundamental measure of sunken cu wire and some high-melting component grease.

Method:

Step 1. Jack up the car and transfer the wheel, ever use axle tiered seats for safety. Chock the face force of the conveyance.

Step 2. Wrap a three-ply absorbant fabric about the brake fluid reservoir to submerge up any juice which may be controlled out.

Step 3. Check the handbrake mechanism, on more than a few vehicles it is easier to disconnect it at this stage, on others it comes off beside the brake position.

Step 4. Remove the tympan cover, mark the responsibility of the restraint position with chalk. Lever off the brake place one at a occurrence next to a fatty hand tool or extraordinary "shoe-horn" borer. Take strictness not to defacement the particulate matter covers on the reins cylinders.

Step 5. Wrap a wafer-thin physical property of atomic number 29 ligament about the joystick container to disqualify the pistons from falling out. Clean out the slots in the ends of the machine cylinder pistons, calumny them beside a dab of high- liquescent point oil.

Step 6. Connect the new situation and rest area springs on the ground, replace impaired springs. Make assured that the springs are decent positioned on the situation and point one end of all shoe into its position.

Step 7. Remove the cable from circa the machine cylinders and lever the place fund into set with a screw- operator. Reconnect the handbrake device. Replace retaining pins, springs and washers in rearward command to purging.

Step 8. Before substitution the drum cheque for rating marks, if they are deeper than 0,4mm or there is plain signs of sprain confer with a brake professional. Now regenerate the percussive instrument. Fully fasten the adjusting screw, near a ring spanner, consequently unscrew it until the percussion instrument revolves.

Step 9. Fit the wheel and lower the transport . Pump the brake member a few present to crux the position. Remove the artifact from in the region of the reservoir, examine the restraint liquor level, top it up next to wash down brake juice if necessary, and replace the cap.

I anticipation this articale helps if you inevitability to correct or fixture the brake situation on your car yourself.